Scissor Lift Certification British Columbia

Scissor Lift Certification British Columbia - Many worksites and tradespeople like for instance iron workers, welders and masons make use of scissor lift platforms to help them reach elevated work areas. The use of a scissor lift is often secondary to their trade. Hence, it is essential that all operators of these platforms be trained properly and certified. Lift manufacturers, regulators and industry work together in order to make sure that operators are trained in safely using work platforms.

Work platforms are otherwise known as manlifts or AWPs. These equipment are stable and easy to use, even if there is always some danger because they raise individuals to heights. The following are various key safety issues common to AWPs:

There is a minimum safe approach distance (also known as MSAD) for all platforms so as to protect from accidental discharge of power due to nearness to wires and power lines. Voltage can arc across the air and cause injury to employees on a work platform if MSAD is not observed.

To ensure maximum stability, care must be taken when the work platform is lowered. When you move the load towards the turntable, the boom should be retracted. This will help maintain steadiness if the -platform is lowered.

The rules about tie offs do not mandate people working on a scissor lift to tie themselves off. Several organizations would on the other hand, need their employees to tie off in their employer guidelines, local regulations or job-specific risk assessment. The anchorage provided by the manufacturer is the only safe anchorage wherein harness and lanyard combinations must be connected.

It is vital to observe and not go beyond the maximum slope rating. The grade could be measured by laying a board on the slope or by laying a straight edge. Afterward, a carpenter's level can be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, you could determine the percent slope.

A standard walk-around check must be done to determine if the unit is mechanically safe. A site assessment determines if the work place is safe. This is important especially on changing construction locations because of the risk of obstacles, unimproved surfaces, and contact with power lines. A function test has to be performed. If the unit is utilized correctly and safely and correct shutdown procedures are followed, the risks of accidents are really lessened.

Click to Download the pdf